This kit started out life as a S.F.3.D Original kit From Nitto Series 4 1/20th scale kit # 0104. The kit is no longer available, "But there are rumors that the line will be released again". As for history of the model I depicted it as a derelict found in the Ruins of Seattle. The ruins are depicted as if the suit was fighting In a factory setting, with the operator missing in action.

The entire Nitto line of SF3D model's are a fun fantasy way of looking at future conflict. The kit it self is a pretty straight forward build. The kit consists of 120 or so parts. The instructions are very easy to follow with a neat story about the history and specs on the bottom of the box. 

Since this model was to be a wreck I took a grinder and thinned out the inside of the body to create the impact and exit holes on the main body. Once this was done I took the same grinder to the exterior and dimpled the plastic to replicate wear and tear that could happen after a life of combat.

The rest of the kit was built out of the box. One note when assembling one of these kits is to open up the joint holes for freedom of movement other wise you will have a very still model that does not move very much. Once the kit was assembled I started on the base. I took a section from an old VLS Stalingrad factory ruin and cut it down to match the size of the model. Various plastistrut beams and tube for piping were also used. 

Markings were not used as this model depicts a wreck that has been sitting for hundreds of years. Painting is where the fun started on this model. Once assembled and the seams were filled. I lightly primed the model using Plasti-Kote automotive sandable primer T-235. This primer is by far the best and easiest to use primer available today. Once the priming and sanding were complete the rusting began.

Using Rustall the entire model including several of the base elements were completely covered in a base of rust. Once dry the first coat was dry I sealed it with matt Krylon krystal clear acrylic spray paint. A second coat of rust was again applied with a 25% mixture of baking soda added to the Rustall in strategic places. This replicates lifting and the oxidation of the metal. Once this is dry seal again with the matt coat. I let the model dry over night then mixed a paste of Kosher salt with a few drops of water. Right before the water completely dries I sprayed the entire model. I waited until the model was dry to the touch. Using a paper towel I rubbed the salt off the painted model. This created an effect of very old rusted paint. The same process was used ffor elements of the base. Weathering was done using MIG pigments and Filters.

The Skull was made using a metal skull found on an old keychain. I made a rubber mold then cast it out of urethane resin. The helmet is from the kit after grinding out the head inside to make room for the skull. The various rubble on the base was made using greeblies supplied from my parts box. I added a piece of polished black acrylic for the bottom of the base.

The entire project took about 25 hours to complete. It was a fast and very satisfying project and a release form the old standby of armor and aircraft. I highly recommend building something like this as it allows you to use your imagination to create something out of the norm.

John Geigle

April 2008

Copyright ModelingMadness.com