It often happens that a stop-gap measure ends up being more widely used than the often delayed version. This is what happened in regards to the Spitfire VIII. Delays in getting the aircraft in production resulted in the Spitfire IX, which used extant airframes of Mk V's (which were often rebuilds of Mk I and Mk II aircraft) along with the new Merlin 61 engine to get the plane into the hands of pilots. Sure, Mk. IX aircraft were built brand new, but they were supposed to be the Mk. VIII.

The Mk VIII came about in a rather different manner. They were supposed to be low altitude derivatives of the Spitfire VI and VII high altitude fighter, but without the cockpit pressurization and the extended wing tips (though some were built with them as high altitude fighters. Go figure). The Mk. VIII can be distinguished from its hybrid Mk. IX cousin by the retractable tail wheel and additional doors. In most other respects, the airframes are the same. Thanks to the head start of the Mk IX, only 1650 Mk. VIII were built, compared to over 5,600 Mk. IXs. Many of the Mk VIII aircraft were used by Britain's allies, mainly the US and Australia. Principally, they were used in the Mediterranean as well as Burma and the Southwest Pacific.

Pop open the box and you see what one expects from a Hasegawa 1/72 kit; a bunch of different sprues. Now this isn't a new kit, with a date of 1997 (that is 8 years ago, folks), but little has changed at the house of Hasegawa. You still have nicely engraved panel lines; you still have a bunch of interchangeable sprues to make sure that you can do only the kit boxed, and you still have those nice decals where white is ivory (thankfully, that seems to have finally changed).

Doing the usual intensive scan of the parts for things like ejector pin marks, flash and sink areas, I find two of the three. As usual, the ejector pin marks are on the inside of gear doors, landing gear legs, the center of the seat pan, and the back of the wheels. Sink areas are on the other side of the gear doors. The cockpit is adequate for the job with a floor, seat, control stick, as well as fore and aft bulkheads. The fore bulkhead has the blank instrument panel face awaiting its decal. Other items of interest are the large centerline tank that gave great range but also a huge speed and maneuverability penalty. It was rarely used in combat.  There are also separate exhaust doors for the coolers.

Instructions are what we have come to expect from Hasegawa. Well drawn, unambiguous as to where things are to be placed with ready color references. As has been the case for the last 20 years or more, these are from the Gunze line, and if Gunze doesn't make it, you'll have to mix it. Markings are given for two RAAF aircraft from 457 Sq. First  is Clive Caldwell's mount and is painted in Dark Earth/Dark Green (which is given as FS 34079) over Light Grey (which is given as FS 36270). The other is an aircraft from later in the war when shark mouths became the norm. It seems as if  each plane were named after a shark and this one is Grey Nurse. It is in that FS 34079 Dark Green and a mixed Grey upper over FS 36270 Light Grey. I'm thinking that mixed grey may be Ocean Grey. Decals are so typical of the period. They are a bit thick with ivory-colored white. They work well when dipped in hot water but using setting solutions is asking for trouble.